Peugeot 308 Key Fob Replacement

Peugeot's 308 might seem a little old however it's still striking. It's not the plushest car in its class but an Ford Focus or Volkswagen Golf will help you stay away from imperfections on the road - but it's a relaxing and comfortable drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following suggestions will help whether the problem is ongoing or intermittent.

Water Damage

If you happen to leave your fob in a puddle or splash it with water while kayaking, swimming canoeing, rafting or canyoning, it's most likely to be damaged by water. The best method to prevent this from happening is to always keep it in a dry bag when you're going outdoors or doing activities that require the fob to be exposed to a lot of water.

You should also ensure that the fob is completely dry prior to opening it and reusing it. If you notice any odors coming from the fob, like an industrial liquid smell or windshield washer fluid, this is another indication that it's been submerged in water.

A wet circuit may cause the battery's charge to drain or even explode. If you are able to get the 308 keyfob from the water and turn it upside up and shake as much water out as you can prior to opening the casing. Once you have opened it, take out the battery and wipe the circuit board using an abrasive soaked in 90-percent isopropyl alcohol.

Other reasons your Peugeot 308 remote entry keyless system may not work include a dead coin-cell battery or receiver module malfunction, signal interference or a faulty chip. If none of these is the problem, you can try resetting your system by disconnecting the 12 volt battery for about 15 minutes.

Dead Coin Battery

Peugeot cars come with a remote-start feature that allows the driver to start the car from afar and then warm up or cool down the vehicle prior to stepping inside. This feature is very beneficial particularly during the cold winter months. But sometimes, the remote stop system stops working due to a variety of causes, such as the battery of a coin that is dead.

The coin-shaped battery located within the key fob may last between two and four months, depending on how often it is used, the location it was purchased, and how it is used. The use-by date will be displayed on the packaging or marked in the user manual.

If the key fob is no longer functioning after being exposed to water that is clean, remove the battery and clean the electronic chip using a paper towel soaked in isopropyl ethanol. Then dry the chip completely before replacing it. In case of exposure to salty or soapy water, the chip could be damaged and you'll have to replace the key fob in total.

If you are not sure the battery is in good condition, you can test its voltage with a multimeter that is set to the vehicle's voltage range and connected to the terminals for minus and plus. The voltage should be around 12-13 volts, but if it is lower, the battery should be replaced. If you want to, you can try to reset your on-board computer by disconnecting the battery at 12 volts for a couple of minutes, and reconnecting it in reverse order (positive cable first and then negative). The engine should begin to run after this.

Faulty Receiver Module

If you don't see the "Key Detected" you might find that your receiver module is defective. It's the part that transmits a signal when your key fob activates. It also acts as an alarm that stops the car from starting without the correct key.

This could be due to a variety of causes including water damage or simply getting old. If your Peugeot 308 key fob has been exposed dirty tap water, like the electronic chip located inside the device will be damaged. In this scenario you'll have to take off the battery and thoroughly clean it with isopropyl alcohol, or electronic cleaner. Once it's dry you can put the battery back in and test it again.

If the issue isn't resolved you're probably in need of a idea to see an area Peugeot specialist or locksmith. They'll be able use a diagnostic tool to identify the issue and fix it.

Losing your Peugeot car keys could be a stressful experience. A professional auto locksmith will be able to solve the problem within minutes. They can cut a brand new key and programme it to your vehicle, so you're to the road as quickly as possible. Click here to find a locksmith near you.

Faulty Electronic Chip

The electronic chip in the Peugeot 308 key fob is an important part of the remote control system. If it gets damaged, your car may not start or you may get a message saying "anti-theft active". In this scenario the only option is to replace the key. Luckily, auto locksmiths who are professionals can offer the service in the shortest time.

The chip inside the chip of your Peugeot 308 key fob can be damaged by sweat, water damage dirt, or any other cause. If your Peugeot 308 key fob has been exposed to soapy water, clean it right away. You can make use of a towel and isopropyl alcohol for cleaning the electronic component. The battery must then be allowed to dry completely.

Radio interference can cause a key fob's functionality to cease. This could be caused by other devices operating at the same frequency as your Peugeot key fob. It can also be caused by weather conditions or objects in the vicinity. If you experience this problem it is recommended to visit the peugeot 207 key replacement dealership.

The Peugeot key fob 207/308 is extremely delicate and requires attention. It should not be dropped or throw it around. If you lose it, try to find it as soon as you can. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a short period of time. Be sure to disconnect the negative first, and then the positive.